Hi Guest
e.g. - "communication: RFID" Search tips
Find Projects
Model: 429    
1 MATCHING PROJECTS

Solderable DIY project kit for Engineering & Diploma students

Product of choice for Engineering & Diploma students worldwide.

Do-It-Yourself Kit

Rs. 10,499

Rs. 9,450

Includes complete hardware with plain PCB and a pre-programmed controller for building the project. Extensive documentation for project execution including step-by-step instructions for Circuit building, Assembly procedure and Troubleshooting. Thorough understanding from the Problem definition to Circuit Design to Programming, Testing, Troubleshooting and finally building a working hardware project.

Tool Kit

(Recommended)

Rs. 0

Includes Digital Multimeter, Soldering Iron, Screw driver, Cutter, to be used with Do-It-Yourself Kit to build the project.

Loaded and Tested PCB

(Optional)

Rs. 0

Pre-soldered and tested PCB. Choose this option only if you are short on time. Only works along with the Do-It-Yourself Kit. (Can be purchased later)

Total Rs. 0

Rs. 0 ( You Save Rs. 0 )

Buy

PROJECT DESCRIPTION

The project is designed to control AC power to a load by using firing angle control of thyristor. The efficiency of such a power control is very high compared to any other method.

The project uses zero crossing point of the waveform which is detected by a comparator whose output is then fed to a microcontroller. The microcontroller provides required delayed triggering control to a pair of SCRs through opto isolator interface. Finally the power is applied to the load through the anti parallel SCRs in series.

This project uses a microcontroller from the PIC16F8 family, which is interfaced through a push button switch for increasing or decreasing the AC power to the load. A lamp is used in place of an induction motor ( not included) whose varying intensity demonstrates the varying power to the motor. The varying power would result in variation in speed of the motor if used in place of lamp.

The project can be further enhanced by using direct 230 volt supply instead of 12 volt AC to the bridge rectifier for achieving higher voltage control for charging a number of batteries in series.

PROJECT HIGHLIGHTS
Easy to use, Self-explanatory kit.
All-inclusive solution kit.
Extensive audio-visuals available.
Branding-free material.
Pre-programmed Microcontroller.
Call/mail for Tech Support from 10 am - 7 pm.
Can be Customized for Arduino, Raspberry Pi, PIC
BLOCK DIAGRAM
Thyristor Controlled Power for Induction Motor using PIC Microcontroller
Hardware Requirements
  • PIC16F8 series Microcontroller
  • LM358
  • Opto isolators
  • SCRs
  • Push Button
  • Transformer
  • Diodes
  • Voltage Regulator
  • Resistors
  • Capacitors
  • Crystal
  • Lamp.
Software Requirements
  • CCS C Complier & MPLAB
  • Languages: Embedded C or Assembly
PROJECT RESOURCES
READ WHAT OTHERS HAVE SAID
Be the first person to review this project
WRITE A REVIEW
Name
Email
Location
Feedback
Please enter security code
Price
Value
Rating Breakdown (0 Reviews)
0
0
0
0
0

Tool kit cannot be purchased individually.

SIGN UP FOR NEWSLETTER

Edgefx Technologies Pvt. Ltd.,
Plot No. 105, 3rd Floor,
Liberty Plaza, Himayathnagar,
Hyderabad - 500029,
Telangana, India
© 2012 Edgefx Technologies Pvt Ltd. All Rights Reserved