he demand for electricity is increasing every day and frequent power cuts is causing many problems in various areas like industries, hospitals and houses. An alternative arrangement for power source is a must.
In this project uses four switches to demonstrate the respective failure of that power supply. When any of the switches is pressed it shows the absence of that particular source, switches are connected to microcontroller as input signals. A microcontroller of 8051 family is used.
The output of microcontroller is given to the relay driver IC, which switches appropriate relay to maintain uninterrupted supply to the load. The output shall be observed using a lamp drawing power supply from mains initially. On failure of the mains supply (which is actuated by pressing the appropriate switch) the load gets supply from the next available source, say an inverter.
If the inverter also fails it switches over to the next available source and so on. The current status, as to which source supplies the load is also displayed on an LCD. As it is not feasible to provide all 4 different sources of supply, one source with alternate switches are provided to get the same function.
The project can be further enhanced by using other sources like wind power also and then taking into consideration for using the best possible power whose tariff remains lowest at that moment.
Easy to use, Self-explanatory kit.
All-inclusive solution kit.
Extensive audio-visuals available.
Call/mail for Tech Support from 10 am – 7 pm.
Can be Customized for Arduino, Raspberry Pi, PIC
- 8051 series Microcontroller
- Relay Driver IC
- Volatge Regulator
- Push Buttons
- Keil compiler
- Language:Embedded C or Assembly.